Replacing a dishwasher control board is one of the easier appliance repairs. On most models it takes 20 to 45 minutes with basic tools. Here is the general process; details vary by brand.
Before you start
- Confirm the board is the problem: no power to the panel, a dead or unresponsive touchpad, cycles that will not start, or a board with visible burn marks.
- Find the part number on the old board. Some dishwashers have two boards: a main control board near the bottom and a user interface board in the door. Make sure you order the right one.
- Take a photo of every connector before you unplug anything.
Safety first: always unplug the appliance and shut off the water (and gas, if any) before you open any panel. If you are not comfortable working with electrical parts, call a qualified technician.
Steps
- Turn off power at the breaker and shut off the water supply.
- Locate the board. On many Whirlpool, KitchenAid and GE models the control is inside the door: remove the screws on the inner door edge and separate the outer panel. On many Bosch, Samsung and LG models the main board sits behind the bottom kick plate.
- Unplug the connectors one at a time. Press the locking tabs; never pull on the wires.
- Remove the old board from its housing or bracket.
- Install the new board in the same position and reconnect every connector using your photos.
- Reassemble the door or kick plate, restore power and water.
- Run a short test cycle and watch for leaks and error codes.
Tips
- Some boards, especially on Bosch dishwashers, must match the software version for your model. Always match the full part number.
- If the new board shows the same fault, check the wiring harness and door switch before ordering anything else.
Need a replacement? Search our catalog by the part number on your old board, or browse dishwasher control boards. Every board is a genuine OEM part, ships free in the contiguous US and has a 60-day warranty.